Hot Tub Electricity Cost Calculator
Enter your heater size, pump use, climate and electricity rate. You get monthly kWh, monthly and yearly cost, and how long and how much it takes to heat a fresh fill.
Last reviewed · How we calculate
Your result
—
- Per day
- —
- Heater
- —
- Pumps and jets
- —
- Per year (incl. refills)
- —
- Heating one refill
- —
- Heat-up time
- —
An estimate, not a bill. Climate presets are rough averages for a covered tub; your utility's usage data or a plug-in or clamp meter gives the real figure.
What drives hot tub electricity cost
A hot tub's electricity cost comes from three things: the heater replacing heat lost through the cover, shell and plumbing; the filtration or circulation pump that runs on a schedule; and the jet pump when you are soaking. The heater is usually the biggest share, and how much it runs depends mostly on outdoor temperature and how well the cover seals — not on the heater's size.
Daily kWh = heating kWh + pump watts × hours ÷ 1,000 + jet watts × minutes ÷ 60,000
Monthly cost = daily kWh × 30.42 × price per kWh
Electric spa heaters are resistance heaters, so nearly all of the power they draw ends up as heat in the water. A 5.5 kW heater uses about the same energy per day as a 4 kW heater; it just reaches temperature faster and then switches off. The climate presets therefore set daily heating energy (2, 4, 8 or 14 kWh a day for warm, mild, cold and very cold), and the calculator shows how many hours that means for your heater.
Worked example
A covered 400 gallon tub in a mild climate: about 4 kWh a day of heating (one hour of a 4 kW heater), a 250 W filtration pump for 8 hours (2 kWh) and a 1,500 W jet pump for 20 minutes (0.5 kWh). That is 6.5 kWh a day, about 198 kWh a month. At $0.18 per kWh it costs about $35.60 a month, or about $430 a year before refills.
| Climate preset | Heating kWh/day | Total kWh/month | Cost/month |
|---|---|---|---|
| Warm | 2 | 137 | $24.64 |
| Mild | 4 | 198 | $35.59 |
| Cold | 8 | 319 | $57.49 |
| Very cold | 14 | 502 | $90.34 |
The presets are rough starting points rather than measurements. As a reality check, California requires portable electric spas sold there to meet a standby power limit tested under set conditions, and the resulting energy label is published. If your spa has one, multiply its standby watts by 24 and divide by 1,000 for kWh per day before anyone uses it — a 210 watt rating, for example, works out to about 5 kWh a day or roughly 150 kWh a month, covering heating and filtration with the cover on. Real use, with the cover open and jets running, adds to that.
Heating a fresh fill
Every refill starts with cold water. Water takes 8.345 BTU per gallon to warm by 1 °F, and 3,412 BTU equals 1 kWh.
Heat-up kWh = gallons × 8.345 × (set °F − fill °F) ÷ 3,412
Warming 400 gallons from 55 °F to 102 °F takes about 157,000 BTU, or 46 kWh — about $8.30 at $0.18. A 4 kW heater needs at least 11.5 hours, a 5.5 kW heater about 8.4 hours, and a 1 kW plug-in heater about two days, all longer in practice because the tub loses heat while it warms. Keep the cover on during heat-up. How often you refill comes from the hot tub drain and refill calculator.
Your electricity rate
The default of $0.18 per kWh reflects the US average residential price: the Energy Information Administration reports 17.23 cents per kWh for 2025 and 18.19 cents for January through August 2026. Rates vary widely between states and plans, and some utilities charge more at peak times. Use the total cost per kWh from your bill, including delivery charges. If you have time-of-use pricing, set the filtration and heating schedule to cheaper hours.
Ways to lower the cost
- Replace a waterlogged or torn cover. A heavy, sagging cover has lost much of its insulation.
- Lower the set point a few degrees when you will not use the tub for several days, rather than turning it off in freezing weather.
- Shield the tub from wind with a screen, fence or plants.
- Run filtration only as long as the manual requires to keep the water clean, and keep the filter clean so the pump moves water easily.
- Know your volume — the hot tub volume calculator — so heat-up estimates and chemical doses are right.
Hot tubs run on dedicated circuits, usually 240 V with a GFCI disconnect. Any wiring changes, including converting a 120 V tub to 240 V, should be done by a licensed electrician.
Questions people ask
How much does it cost to run a hot tub per month?
At 18 cents per kWh, a typical covered 400 gallon tub using about 6.5 kWh a day costs around $36 a month. Warm climates can be closer to $25, and cold winters can push it to $55 to $90 or more.
How many kWh does a hot tub use?
With a good cover, roughly 4.5 to 16.5 kWh a day depending on climate and use, or about 140 to 500 kWh a month.
How much does it cost to heat a hot tub from cold?
Heating 400 gallons from 55 °F to 102 °F takes about 157,000 BTU, or 46 kWh. At 18 cents per kWh that is about $8.30, and a 4 kW heater needs at least 11.5 hours to do it.
What is the average electricity rate in the US?
The US Energy Information Administration reports an average residential price of 17.23 cents per kWh for 2025 and 18.19 cents for January to August 2026. Your own bill gives the rate that matters.
Does a bigger heater cost more to run?
Not much. Electric resistance heaters turn almost all their power into heat, so a 5.5 kW heater uses about the same kWh as a 4 kW heater to replace the same heat loss; it just runs for fewer hours. Cover quality and climate matter far more.