Pool Dose Lab

Pool Evaporation Calculator

Enter your pool's surface area and a daily evaporation rate to see gallons lost per day, week and month, the refill cost, the effect of a cover, and whether your water loss looks like a leak.

Last reviewed · How we calculate

Water surface
Enter the surface as
Evaporation

Rough planning figures. The bucket test below gives your real rate.

Period, cost and leak check

Example — use your bill.

Measured over 24 hours.

Your result

—

One inch of water
—
Per week
—
Per 30 days
—
Over your period
—
Refill cost
—
Leak check
—

The leak check flags any loss more than 1/8 in a day above the expected evaporation. Splashing, backwashing and rain overflow also lower the level, so test on a quiet day.

How the pool evaporation calculator works

Evaporation takes water from the surface only, so the amount you lose depends on surface area, not on how deep the pool is. A pool evaporation calculator multiplies your water surface by the depth that evaporates each day, then converts cubic feet to gallons. One square foot of water one inch deep is 0.623 gallons, which is the number behind every result above.

Gallons per day = surface area (sq ft) × inches per day ÷ 12 × 7.48 With a cover: inches per day × (1 − cover reduction %) Refill cost = gallons ÷ 1,000 × price per 1,000 gallons

What drives evaporation

Water evaporates faster when it gains more heat energy and when the air above it can take up more moisture. In practice that means four things: sun on the water, wind across it, dry air, and water that is warmer than the air. A heated pool on a cool, breezy night can lose more than an unheated pool on a still, humid afternoon. Because these vary so much by place and season, the presets in the calculator are rough planning figures, not measurements for your yard. Losses of about 0.1 to 0.5 inch a day cover most residential situations; desert pools in summer can exceed that, and a covered or indoor pool loses far less.

Gallons lost per day by surface area and evaporation rate
Surface0.1 in/day0.2 in/day0.3 in/day0.5 in/day
300 sq ft19375694
400 sq ft255075125
512 sq ft (16 × 32)326496160
600 sq ft3775112187
800 sq ft50100150249

Worked example: 16 × 32 ft pool in a warm summer

The surface is 512 sq ft, so each inch is about 319 gallons. At 0.25 inch a day the pool loses about 79.8 gallons daily and about 2,394 gallons over 30 days — roughly 7.5 inches of level if you never topped up. At an example water rate of $6 per 1,000 gallons, that month of top-ups costs about $14.36. With a cover that cuts losses by 40%, daily loss falls to about 47.9 gallons and the month's total to about 1,436 gallons, saving roughly 958 gallons.

Covers and evaporation

A cover blocks the sun and wind at the surface and traps humid air against the water. The US Department of Energy's guidance on pool covers says they can reduce the make-up water a pool needs by 30–50%; the result depends on how many hours a day the cover is actually on. The same guidance says savings of 50–70% on pool heating are possible, because evaporation is also the main way a pool loses heat. If you heat your pool, see how much a cover changes the numbers in the pool heater size calculator.

Is my pool leaking? The bucket test

If your pool drops faster than this calculator expects, compare it with a bucket that evaporates under the same conditions:

  1. Fill the pool to its normal level and fill a bucket with pool water to about 1 inch from the top.
  2. Set the bucket on the first or second step so it sits in the pool water. Weigh it down if it floats.
  3. Mark the water level inside the bucket, and mark the pool level on the outside of the bucket or on the skimmer.
  4. Leave the pump on its normal schedule, with no swimming, auto-fill, backwashing or rain, for 24 hours.
  5. Compare the two drops. Both lost water to the same sun and wind, so if the pool dropped clearly more than the bucket, the extra is probably a leak.

Run the test a second time with the pump off. If the pool loses more with the pump running, suspect the pressure side of the plumbing; if it loses more with the pump off, suspect the suction side. If the loss is the same either way, the shell, liner, light niche or a fitting is more likely. Enter the pool's measured drop as "Your pool's drop" above: the calculator flags anything more than about 1/8 inch a day above expected evaporation, which is this calculator's rule of thumb for "worth investigating", not an industry standard.

Evaporation removes pure water and leaves salt, calcium and stabilizer behind, so a pool that only evaporates slowly concentrates them. A pool that leaks loses chemicals along with the water — a falling salt or stabilizer reading with no draining is another hint of a leak.

Topping up

Add water when the level falls toward the bottom of the skimmer opening; a skimmer that draws air can make the pump lose prime. The fill time calculator turns gallons into hose hours. In a salt pool, evaporation plus top-ups does not lower the salt level — salt only leaves with splash-out, backwash and leaks — so use the salt calculator only when the reading actually drops.

Questions people ask

How much water does a pool lose to evaporation?

It depends on sun, wind, humidity and water temperature, but losses of roughly 0.1 to 0.5 in per day are a reasonable planning range. A 16 × 32 ft pool losing 0.25 in a day gives up about 80 gallons a day, or about 2,394 gallons a month.

How many gallons is one inch of pool water?

Each square foot of surface holds about 0.623 gallons per inch of depth. A 16 × 32 ft pool (512 sq ft) holds about 319 gallons per inch, and a 300 sq ft pool about 187 gallons.

Is my pool leaking or evaporating?

Do the bucket test: set a bucket of pool water on the top step so its water level matches the pool, mark both levels, and compare after 24 hours with the pump on its normal schedule. If the pool drops noticeably more than the bucket, you likely have a leak.

Does a pool cover stop evaporation?

A cover that is on the pool cuts evaporation sharply while it is in place. The US Department of Energy says a pool cover can reduce the make-up water needed by 30–50%, depending on how often it is on the pool.

Does a heated pool evaporate faster?

Yes. Warmer water evaporates faster, especially when the air is cooler and drier than the water, such as on cool nights. That is one reason heated pools benefit so much from a cover.

Sources and references