Pool Volume Calculator
Pick your pool's shape, enter its length, width and depths in feet or meters, and get the volume in gallons, liters and cubic feet — saved for every other calculator on this site.
Last reviewed · How we calculate
Your result
—
- US gallons
- —
- Liters
- —
- Cubic feet
- —
- Cubic meters
- —
- Imperial gallons
- —
This volume is saved in your browser and filled in automatically on the other calculators. Use it in the salt calculator, the chlorine calculator or the test results calculator.
Why your pool volume matters
Every chemical dose is a concentration, so every dose depends on how much water you have. A pool volume calculator turns your pool's measurements into gallons; get that number wrong by 20% and every bag of salt, jug of chlorine and cup of acid will be off by 20% too. Measuring once, carefully, saves you money and guesswork for as long as you own the pool. The result above is stored in your browser, so the chemical calculators on this site start with your gallons already filled in.
How the pool gallons calculation works
The calculator first finds the water's volume in cubic feet, then converts it: one cubic foot holds 7.48 US gallons, and one US gallon is 3.785 liters. The depth used is the average of the shallow and deep ends, which is accurate for a pool with a steady slope and close enough for most pools with a hopper.
Rectangle or freeform: length × width × average depth × 7.48 Round: 3.1416 × (diameter ÷ 2)² × average depth × 7.48 Oval: 3.1416 × (length ÷ 2) × (width ÷ 2) × average depth × 7.48 Kidney: 0.45 × (wide-end width + narrow-end width) × length × average depth × 7.48 L-shape: (main length × main width + leg length × leg width) × average depth × 7.48
The kidney factor of 0.45 is a widely used industry approximation, not an exact geometric result, and the oval formula assumes a true ellipse. If your oval has straight sides and rounded ends — the usual shape for above-ground ovals — use the above-ground pool gallons calculator, which treats it as a rectangle with a half circle at each end. For a freeform pool, measure the length at a few points and the width at three or four points, average each set, and enter those averages.
Worked example: a 16 × 32 ft pool
Take a classic 16 by 32 ft rectangle that goes from 3.5 ft at the steps to 6 ft at the deep end. The average depth is (3.5 + 6) ÷ 2 = 4.75 ft. The water occupies 16 × 32 × 4.75 = 2,432 cubic feet, and 2,432 × 7.48 = about 18,193 US gallons, or 68,867 liters (68.9 m³). If you had assumed a 5 ft average, you would have estimated about 19,150 gallons and overdosed everything by roughly 5%.
In metric, a 10 × 5 m pool running from 1.2 m to 2.0 m averages 1.6 m deep, which is 80 m³: 80,000 liters, or about 21,134 US gallons.
Common pool sizes in gallons
| Shape and size | Depth | US gallons | Liters |
|---|---|---|---|
| Rectangle 10 × 20 ft | 3.5–5 ft | 6,358 | 24,069 |
| Rectangle 12 × 24 ft | 3.5–5 ft | 9,156 | 34,660 |
| Rectangle 14 × 28 ft | 3.5–6 ft | 13,929 | 52,726 |
| Rectangle 15 × 30 ft | 3.5–6 ft | 15,990 | 60,527 |
| Rectangle 16 × 32 ft | 3.5–6 ft | 18,193 | 68,867 |
| Rectangle 18 × 36 ft | 3.5–8 ft | 27,872 | 105,509 |
| Rectangle 20 × 40 ft | 3.5–8 ft | 34,410 | 130,257 |
| Kidney 16 / 10 × 32 ft | 4.5 ft average | 12,603 | 47,708 |
| Oval (ellipse) 15 × 30 ft | 4.5 ft average | 11,897 | 45,036 |
| L-shape 30 × 16 ft plus 10 × 8 ft leg | 3.5–6 ft | 19,898 | 75,323 |
How to measure your pool
- Measure length and width at the water line with a tape, wall to wall. Ignore the coping or deck overhang.
- Measure depth from the water surface straight down to the floor at the shallowest point and at the deepest point. A pole with tape marks or a weighted string works well.
- For an L-shape, split the pool into two rectangles that do not overlap: the main body, plus the leg that sticks out from it.
- For a kidney, measure the width across the widest lobe and across the narrowest lobe, plus the overall length.
- Choose meters if your tape is metric — the calculator converts for you.
Common mistakes
The biggest error is measuring depth to the top of the wall. Water usually sits halfway up the skimmer opening, several inches below the coping, and on a large pool those inches are thousands of gallons. The second is using the deepest point as the depth; a pool with a short deep hopper and a long shallow section has an average well below the midpoint, so take several depth readings along the pool and average them if the floor is not a steady slope. Built-in steps, benches and tanning ledges take up volume too; subtracting them is rarely worth the effort, but it is one reason calculated volumes tend to run slightly high.
Want to check your number? A salt pool gives a built-in test: add a measured amount of salt and see how far the reading moves. In a 15,000 gallon pool, one 40 lb bag should raise the reading by about 320 ppm (the salt calculator does this math). If it only rises 270 ppm after a full day of circulation, the pool holds closer to 17,750 gallons.
What to do with the result
With your gallons known, set your free chlorine target in the chlorine calculator, enter a full set of test results in the pool chemical calculator, or size circulation with the pump size calculator. If you are refilling, the fill time calculator shows how long the hose will run and what the water costs.
Questions people ask
How many gallons is a 16x32 pool?
A 16 by 32 ft rectangular pool that runs from 3.5 ft in the shallow end to 6 ft in the deep end averages 4.75 ft deep and holds about 18,193 US gallons (68,867 liters). The same pool at a uniform 4 ft would hold about 15,320 gallons.
How do I calculate pool gallons?
Multiply length × width × average depth in feet to get cubic feet, then multiply by 7.48 gallons per cubic foot. For a round pool use 3.1416 × radius² × average depth × 7.48 instead of length × width.
How do I find the average depth of a pool?
Add the shallow-end depth and the deep-end depth and divide by two. Measure to the water line, not the top of the wall or coping, because the water is usually several inches below it.
How many gallons is a 24 ft round pool?
A 24 ft round pool with 4 ft of water holds about 13,536 US gallons. Above-ground pools are usually filled to about 6 inches below the top of the wall, so a 48 in wall gives roughly 42 in of water and about 11,844 gallons.
How accurate is a pool volume calculator?
For rectangles and round pools with good measurements, expect results within about 5%. Kidney and freeform shapes are estimates, often within 10%; the best check is a water meter reading while filling, or a salt or chemical dose that moves the reading by a known amount.